1
EN
Warnings
When Dielectric Voltage Withstand Test is done on an installation, it is important to disconnect the
terminal J1 on the GLB main board.
This equipment should not be used by anyone (including children) with reduced physical, sensory
or mental capacity, or anyone lacking in experience or knowledge, unless they are provided with
supervision or prior instruction in how to use the equipment by the person responsible for their safety.
The GLB Wallbox range of charging stations is designed exclusively for charging electric vehicles.
The GLB Wallbox must be grounded according to local country installation requirements.
Do not install or use the GLB Wallbox near flammable, explosive, harsh, or combustible materials,
chemicals, or vapors.
Turn off the electrical power at the circuit breaker before installing, configuring or cleaning of the GLB
Wallbox.
Use the GLB Wallbox only within the specified parameters.
Never spray water or any other liquid directly at the GLB Wallbox. Never spray any liquid onto
the charge handle or submerge the charge handle in liquid. Store the charge handle in the dock to
prevent unnecessary exposure to contamination or moisture.
Do not use this equipment if it appears to be damaged or if the charging cable appears to be
damaged.
Do not modify the equipment installation or any part of the product.
Do not touch the GLB Wallbox’s end terminals with fingers or any other objects.
Do not insert foreign objects into any part of the GLB Wallbox.
TABLE OF CONTENTS
Warnings 1
Cautions 2
Notes 2
Installation of standalone GLB Wallbox 3
Normal Use/Charging 4
Basic LED indications 5
Software GLB 5
Service/Maintenance 5
Troubleshooting/Support/FAQ mm 5
Technical specifications 5
Installation sketch 6
Warranty form 10
Warranty conditions 11
To Next Page
Loading...
