Need help?Do you have a question about the Garrard TA/MK II and is the answer not in the manual?
Connecting the flexible lead for power supply and checking voltage/frequency links.
Soldering the screened pickup lead to the terminal panel.
Setting terminal block links for correct voltage and frequency.
How to earth the motor and ensure pickup circuit isolation for safety.
Checking motor pulley for correct speed based on power supply frequency.
Steps to take if the motor fails to start, checking power and contacts.
Required stylus types and ensuring the correct one is used.
How to adjust stylus pressure using the screw and checking with a gauge.
To Next Page
General
