Operation
Operation Instructions
COOL operation
-Press the "MODE" button until the "COOL" indicator light comes on.
-Press the ADJUST buttons "+" or "-" to select your desired room
temperature. The temperature can be set within a range of
17°C~30°C/62°F~86°F.
-Press the "FAN SPEED" button on the remote controller to choose the
fan speed.
FAN operation
-Press the "MODE" button until the "FAN " indicator light comes on.
-Press the "FAN SPEED" button on the remote controller to choose the
fan speed. The temperature cannot be adjusted.
-Do not put the duct to the window.
SLEEP/ECO operation
This feature can be activated from the remote control ONLY.
To activate SLEEP feature, the set temperature will increase by
1°C/2°F) in 30 minutes. The set temperature will then increase
by another 1°C/2°F) after an additional 30 minutes. This new
temperature will be maintained for 7 hours before it returns to the
originally selected temperature. This ends the Sleep mode and the unit
will continue to operate as originally programmed.
NOTE: This feature is unavailabe under FAN and DRY modes.
DRY operation
-Press the "MODE" button until the "DRY" indicator light comes on.
-Under this mode, you cannot select a fan speed or adjust the
temperature. The fan motor operates at LOW speed.
-Keep windows and doors closed for the best dehumidifying effect.
-Do not put the duct to the window.
AIRFLOW DIRECTION ADJUSTMENT
Adjust the airflow direction manually:
-The louver can be set to the desired position manually.
-Do not place any heavy objects or other loads on the louver because,
doing so will damage the unit.
-Ensure the louver is fully opened under heating operation.
-Keep the louver fully opened during operation.
Other features
FOLLOW ME/TEMP SENSING feature(optional)
NOTE:This feature can be activated from the remote control ONLY. The
remote control serves as a remote thermostat, allowing for precise
temperature control at its location. To activate the Follow Me/Temp
Sensing feature, point the remote control toward the unit and press the
Follow Me/Temp Sensing button. The remote display shows the actual
temperature at its location. The remote control will send this signal to
the air conditioner every 3 minutes until the
Follow Me/Temp Sensing button is pressed again. If the unit does not
receive the Follow Me/Temp Sensing signal during any 7-minute interval,
the unit will exit the Follow Me/Temp Sensing mode.
NOTE: This feature is unavailabe under FAN and DRY modes.
AUTO-RESTART
If the unit turns off unexpectedly due to power loss,it will automatically
restart with the previous function setting when the power resumes.
WAIT 3 MINUTES BEFORE RESUMING OPERATION
After the unit has stopped, it cannot be restarted in the first 3 minutes.
This is to protect the unit. Operation will automatically restart after
3 minutes.
11
To Next Page
Loading...
Need help?
General
