Garrison 2498548 User Manual (English)

Questions and Answers:

A
Amanda CombsAug 9, 2025
What to do if my Garrison 2498548 is not cooling or heating the room?
- U
  urobinsonAug 9, 2025
  If your Garrison Heat Pump isn't cooling or heating the room effectively, ensure that curtains, blinds, and furniture aren't blocking the unit's airflow. Try adjusting the temperature setting to be lower or higher. Also, clean the filters. Allow enough time for the unit to heat or cool the room, or start it early. Ensure the vent door is closed and check the dip switch and wall thermostat settings. Note that it may take around 3 minutes for the compressor to start.
C
Charles MartinAug 16, 2025
Why my Garrison 2498548 Heat Pump does not start?
- B
  Benjamin NicholsAug 16, 2025
  If your Garrison Heat Pump isn't starting, check that the plug is securely plugged into the wall receptacle and that the plug has not tripped (it has a test/reset button). Also, replace the fuse or reset the circuit breaker. Finally, make sure the unit is turned on using the bottom right button on the keypad.
J
Judith WilliamsAug 23, 2025
What to do if ice or frost forms on the indoor coil of my Garrison Heat Pump?
- C
  Cameron CooperAug 23, 2025
  If ice or frost forms on the indoor coil of your Garrison Heat Pump, especially when the outdoor temperature is around 55°F or below and the unit is in Cooling mode, switch the unit to FAN operation until the ice or frost melts. Additionally, remove and clean the filters.
E
Elizabeth HerreraSep 1, 2025
Why is water dripping inside my Garrison Heat Pump?
- C
  Courtney HowardSep 1, 2025
  If water is dripping inside from your Garrison Heat Pump, it might be because the wall sleeve isn't installed level. The wall sleeve must be level to ensure proper condensation drainage. Check the installation and adjust as necessary.