Need help?Do you have a question about the GasKnight Pro and is the answer not in the manual?
General| Explosion-proof Grade | Exd II CT6 |
|---|---|
| Sensor Type | Catalytic |
| Power Consumption | <3W |
| Output Signal | 4-20mA, RS485 |
| Working Temperature | -20℃~50℃ |
| Working Humidity | 10-95% RH (non-condensing) |
Lists the required tools for initial setup, such as a small screwdriver.
Instructions on how to replace the batteries when the detector indicates low power.
Guidance on cleaning the detector exterior and sensor, and ideal storage conditions.
To Next Page