5. Insert cooktop into cutout
Insert the cooktop centered into the cutout opening. Make sure the front edge
of the countertop is parallel to the cooktop. Make final check that all required
clearances are met.
6. Attach hold-down brackets to cabinet
Open the cabinet door. Rotate the brackets to overlap with the underside of the
countertop. Then tighten the hex screw. Install the thumbscrew until it touches
the bottom of the countertop.
Important: Turn the thumbscrew until it touches the bottom of the countertop. Do
not overtighten.
Cooktop
Cooktop Base
Cooktop
Countertop
Thumbscrew
Bracket
Hex Screw
17
www.gaslandchef.com
3330-A Marathon Ct Charleston, SC 29418
16
support@gaslandchef.com
1 (844) 538-7890
To Next Page
Loading...
