4 5
PRODUCT MARKINGS
PUSH AND HOLD
TO IGNITE
PILOT
ON
ON
CHARGE
FLASHING - CHARGING
SOLID - CHARGED
POWER OFF
UNIT OFF
BURNER VIEWING WINDOW
PILOT VIEWING WINDOW
(GREEN LED) (RED LED)
CONNECTING & DISCONNECTING
TO GAS SOURCE
Familiarise yourself with the general information and
safety guidelines located at the front of this manual.
Check:
1. Gas cylinder is filled. A sloshing sound will
be heard when shaken.
2. The switch is in the POWER OFF UNIT OFF
centre position.
Connecting Using a Disposable
Propane Canister
1. Attach the regulator to the side of the
appliance, refer Page 4.
2. Regulator will be held in the bracket.
3. Screw in the disposable propane canister.
Connecting Using a Hose & LPG Cylinder
1. Ensure the cylinder valve is in its full off position.
2. Position the gas cylinder as far as practicable
from the appliance and also as far as practicable
from your tent.
3. Check for any damage to either the cylinder
connection or the hose. NEVER attempt to use
damaged equipment.
4. When connecting the hose to the cylinder
tighten the nut to a positive stop by hand.
5. Attach the regulator to the side of the ducted
heater then attach the hose to regulator.
6. Open cylinder valve. Use a soapy water solution
to check the joints. If bubbles appear the
connection will need to be re-tightened.
NOTE: If using POL gas cylinder, ensure gas
cylinder is at least 650mm away from the
heater and in the same side as the regulator
To Next Page
Loading...