34 35
be knotted, twisted, pulled, strained or squeezed. Do not let the plug or power cord
hang over the edge of the table or counter. The power cord may not touch hot sur-
faces or sharp edges. Ensure that no one will pull the appliance by the power cord.
Take care not to entangle in the power cord. Always grasp the plug to disconnect
the power cord. Do not touch the appliance or power plug with wet hands when the
appliance is connected to the power supply.
DONOTletanyliquidsrundowntheexteriorofthejug,whenthe
jugismountedonthepowerbase.Donotplacethejugonthepower
base,whentheexteriorofthejugiswet.Otherwiseliquidcouldrun
intothepowerbase.
When liquids are spilled on the power base or power cord,
immediately unplug the appliance. Thereafter, clean the appliance and let it dry for
at least 1 day (see: ‚Care and Cleaning’).
HIGH TEMPERATURES—RISK OF BURNS
The milk frother is designed for frothing and heating milk, and therefore milk, jug, lid,
and measuring cup can get very hot during operation and shortly thereafter. Please
keep this in mind to avoid scalds and damage.
or any other parts or your body or any heat-sensitive or moisture-sensitive objects. Do
not place the jug on any heat-sensitive surfaces shortly after operation. Only touch
the jug and lid at the handles (e.g. handle of the jug, finger hole at the lid) during
operation and shortly thereafter.
-
on and shortly thereafter. Condensate could accumulate under the lid and measuring
cup and drip, when pouring out the contents of the jug, or when opening the lid.
wine, grog) within the appliance to avoid risk of explosion and fire.
MOVING PARTS
The milk frothing disc of the appliance is driven electrically via a magnet. Thus, you
should always avoid inserting your hands, or any delicate objects in the jug, when
the jug is placed on the power base and the appliance is connected to the power
supply.
TECHNICAL SPECIFICATIONS
Model: Art.-Nr. 42325 Latte Magic / 42326 Latte Magic
Power supply: 220 – 240 V AC, 50 – 60 Hz
Power consumption: 420 – 500 W
Revolutions: 2,500 – 3,000 per minute
Length of power cord: ca. 75 cm
Weight (with lid): ca. 0.88 kg
Dimensions: ca. 15.5 cm x 12.0 cm x 20.0 cm (width x depth x
height)
Capacity: 0.5 Litre
Compliance:
PROPERTIES OF YOUR NEW MILK FROTHER
Your new Milk Frother has been designed specifically for the purpose of foaming
milk and milk alternatives.
IMPORTANT: The appliance is not intended to thicken or heat other food substances
(e.g. custards, soups, gravies), or to whip cream or egg white. Additionally, the
appliance is not intended to mix a large quantity of dry and/or solid ingredients
(e.g. ground nuts, spices, flour, cacao powder, herbs) or melt large pieces of food
(e.g. chocolate or butter).
The frothing disc is driven contact-less via magnets. No opening for a drive shaft is
necessary in the jug, thus avoiding weak points and leaks. As a result, cleaning is
made much easier, too. Due to the seal at the brim of the lid, the contents will not
drip or splash out of the jug, when operated correctly.
SAFETY CONCEPT
For your protection and convenience, your new milk frother offers an innovative
design.
button turns off.
overheats. Wait 30 seconds before turning the appliance back on.
To Next Page
Loading...
Need help?
General
