5. Save the changes by clicking "SAVE".
Troubleshooting
The ROF of my replica does not increase after increasing the motor's rotation speed
Disable the ROF control in the "Trigger" tab.
The motor has reached the maximum adjustment capabilities for your configuration.
Connection error
Make sure you have the latest version of the GCS app and the firmware of your TITAN or ASTER system installed.
Ensure that the motor connectors are properly connected.
Gently tighten the motor connectors to ensure a secure connection. Do not use excessive force to avoid damaging the
connectors of the TITAN or ASTER unit.
If any of the connectors are damaged, replace them with the connectors included in the TITAN or ASTER installation kit.
If the error persists, contact us at support@gatee.eu.
I cannot configure the motor using a 14.8 V battery
The GATE G5 motor can only be configured with 3-cell batteries with a nominal voltage of 11.1 V. Configuration with a 4-cell battery
is not possible.
Technical specifications for 11.1 V
The design and production of the device is based on harmonized standards.
Power supply voltage range 6-16.8 V
Dimensions (length x width x thickness) 88.5 mm x 29.5 mm x 25 mm
To Next Page
Loading...