Gate G5 - Installation

 Warning
Incorrect connection of the motor connectors to the motor will result in immediate damage to the motor, which is not covered by the
warranty and may lead to a fire.
 Caution
For your own safety you ought to use an additional fuse between the battery and the device.
 Note
The product Warranty Form is available here: http://www.gatee.eu/warranty.
Installation
 Caution
Regardless of your previous experience, follow all safety precautions.
 Note
In case you have any difficulties while installing or using this product:
contact us via https://help.gatee.eu
send us an email: support@gatee.eu
join GATE Airsoft Community Discord Server
Installation of the G5 motor in the replica
1. Prepare the replica where you will install the G5 Brushless Motor.
If the replica is equipped with the ASTER II Bluetooth® or TITAN II Bluetooth® unit, you can proceed directly with the motor
installation. You will be able to fully utilize the capabilities of the G5 motor.
For other ETUs, you will not be able to configure the motor via the GCS application.
2. Optional installation of the TITAN II Bluetooth® or ASTER II Bluetooth® unit. Install the TITAN II Bluetooth® or ASTER II Bluetooth®
unit according to the instructions to fully utilize the capabilities of the G5 motor:
TITAN II Bluetooth® installation guide
ASTER II Bluetooth® installation guide
3. Unscrew the pistol grip cover and remove the old motor.
4. Place the G5 motor in the pistol grip.
 Caution
Make sure the wires are not in the area of the hole through which the motor gear passes. If necessary, change the wire positioning.
5. Connect the motor wires of the unit to the motor connectors according to their polarization markings:
Red wire “ ” to red connector “ ”.
Black wire “ ” to black connector “ ”.
 Caution
Do not bend the motor connectors, as this may cause permanent damage, which is not covered by the warranty.
6. Check if you can push the motor into the pistol grip.
 Note
If you encounter any issues, follow these steps: