CHAPTER 3: Replacing notebook components
50
Adding or replacing memory modules
Tools you need to complete this task:
To add or replace memory modules:
1 Complete the steps in “Preparing the notebook” on page 47.
2 Complete the steps in “Removing the bay cover” on page 49.
3 If you are replacing a memory module, go to step 4.
If you installing an additional memory module, go to step 6.
4 Use a non-marring plastic scribe to push out the latches on both sides of
the memory slot until the module tilts upward.
5 Remove the memory module from its slot.
Important
Use only memory modules designed for this Gateway notebook.
Phillips #0 screwdriver
Non-marring plastic scribe
To Next Page
Loading...
