CHAPTER 3: Replacing notebook components
56
Replacing the optical drive
Tools you need to complete this task:
Screws removed during this task:
• 1 black M2.5×6 (optical drive)
• 1 chrome M2×3 (optical drive bracket)
To replace the optical drive:
1 Complete the steps in “Preparing the notebook” on page 47.
2 Complete the steps in “Removing the bay cover” on page 49.
3 Remove the optical drive screw.
4 Use the non-marring plastic scribe to carefully push the optical drive out of
the drive bay, and then slide the drive out.
Phillips #0 screwdriver
Non-marring plastic scribe
To Next Page
Loading...
