www.gateway.com
55
5 If your new hard drive already includes the hard drive bracket, go to step 8.
If you need to use the bracket from the old hard drive, go to step 6.
6 Remove the screws that secure the hard drive bracket, and then detach the
bracket from the drive.
7 Place the bracket on the new drive and secure it with the two screws removed
in step 6.
8 Slide the new hard drive into the hard drive compartment and make sure
it’s properly engaged to the SATA1 connector.
9 Secure the new drive to the system board with the screw removed in step 6.
10 Reinstall the bay cover.
To Next Page
Loading...
