www.gateway.com
63
5 Insert the retaining tabs of the new keyboard into the slots located on the
top side of the touchpad area.
6 Reach underneath the keyboard and insert the keyboard cable to its system
board connector, then close the clip to lock the cable in place.
7 Gently press the keyboard down until it is flat all the way across.
8 Reinstall the keyboard cover by performing steps 9–13 of the “Replacing the
keyboard cover” procedure on page 58.
9 Reinstall the battery.
Important
The keyboard cable is correctly oriented if it is not twisted.
To Next Page
Loading...
