Need help?Do you have a question about the GBC DocuBind TL200 and is the answer not in the manual?
General| Brand | GBC |
|---|---|
| Model | DocuBind TL200 |
| Category | Binding Machine |
| Language | English |
Push the handle onto the punching shaft and secure with a screwdriver.
Insert U shaped wire support bracket into holes on top rear of machine.
Align sheets or covers and insert edge into punch throat for binding.
Jog sheets to be flush against the edge guide and bottom of the punch throat.
Pull handle completely down to punch paper. Punches up to 20 sheets.
Pull selector pin to disengage a punch die for specific paper sizes.
Place large loops of wire element into Wire Holder with small loops facing you.
Place punched pages face up onto wire element loops, then add covers.
Remove wire element from holder, place book into Wire Crimper and pull handle down.
Flip front cover around. Adjust crimper dial if wire is not closed properly.
To Next Page
