4. Installation
Service
WARNING:
Do not attempt to service or repair
the laminator.
Failure
to observe this warning could
result in
severe
personal injury or death.
Disconnect the plug from the receptacle and contact
Customer Service when one or more of the following
has o
cc
urr
e
d
.
•
The
power supply cord or attachment plug is
damaged.
• Liquid has been spilled into the laminator.
• The laminator is m
a
l
f
un
c
t
i
o
nin
g
after being
mishandled.
• The laminator does not operate as described in
these ins
tr
u
c
t
i
o
ns.
Installation
• Shipping damage should be brought to the
immediate attention of the delivering carrier.
• Place the laminator on a stable flat surface
capable of supporting 23 kgs.
• The surface should be at least 75cm high to
assure comfortable positioning during
operation. All four rubber feet should be on the
supporting surface.
• Connect power cord to an appropriate power
source. Avoid connecting other equipment to
the same branch circuit to which the laminator
is connected as this may cause nuisance
tripping of the circuit breaker or blown fuses.
• The laminator should be positioned to allow
exiting film to drop freely to a flat surface.
Accumulation of laminated documents as they
exit the laminator may cause a jam.
• Avoid placing laminator near sources of heat or
cold. Avoid locating the laminator in the direct
path of forced, heated or cooled air.
Caring for Foton 30
The only maintenance required by the operator is to
periodically clean the rollers. Keeping the rollers clean
ensures that your finished items will not be damaged by
dirt and adhesive build-ups.
CAUTION: the following procedure is performed
while the laminator is hot. Use extreme caution.
WARNING: Do not apply cleaning fluids or
solvents to the rollers.
WARNING: Do not attempt to laminate
adhesives marked ‘Flammable’.
WARNING: Do not expose laminator to liquids.
1. Power the machine on, wait for it to completely
warm up.
2. Open the laminator door using the silver latch.
3. Clean the top rollers with a clean, damp lint-free
cloth. If there are any adhesive build-ups, you
may use isopropyl alcohol instead of water.
4. Lift leading film edge up to the handle of the
cartridge.
5. Clean the bottom rollers with a clean, damp lint-
free cloth. If there are any adhesive build-ups,
you may use isopropyl alcohol instead of water.
6. Place the leading film edge into proper position
and close the door.
7. Press and hold the RUN/STOP button for 5-7
seconds to manually advance the rollers.
8. Open the laminator door using the silver latch.
9. Repeat steps 4 – 6.
Note: Do not use metal scouring pads to clean the heat
rollers!
WARNING: Do not laminate glitter and/or
metallic items. Damage to the rollers may result.
The side covers and feed table can be cleaned with a
lint-free cloth and a mild detergent.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
