GBC GBC4250 - Page 25

The “Word Finishing" People
4. Cut the top web of film between the film roll and the top idler bar. Remove
the top roll of film.
5. Remove the bottom roll of film. Cut the bottom web between film roll and
the bottom idler bar.
6. Standing in front of the laminator, reach into the open area on top of the
laminator. Grasp the two sides of the film web spanning the area between
the heat and pull rollers. Avoid contacting the heat rollers.
6. The second individual should depress the REVERSE SWITCH to cause
the pull rollers to rotate in a reverse direction while the first individual
grasping the film pulls the film towards the front of the equipment.
7. Discontinue depressing the REVERSE SWITCH once the film has
unwrapped completely off the pull rollers.
8. Repeat steps 5, 6 and 7 as necessary.
9. Advance the unwound film completely through the laminator by setting the
RUN/STOP switch to the “Run” position. Refer to step 4 in the section
entitled FILM LOADING & THREAQING: Method Using Film ThreadiPfl- Qaid.
for a procedure to prevent exposed liquefied or tacky adhesive from
contacting the heat or pull rollers.
10. Reinstall the top and bottom film rolls per the section entitled FILM
LOADING & THREADING .