GBC GBC4250 - Electrical Safety

The “Word Finishing” People
The heat rollers can operate at temperatures close to 300 °F. Avoid contact
with the heat rollers during operation or shortly after power has been
removed from the laminator.
Keep hands and fingers away from the path of the sharp film cutter blade
located at the area of film exit.
Do not use the laminator for other than its intended purpose.
Do not place the laminator on an unstable cart, stand, or table. An unstable
surface may cause the laminator to fall resulting in serious bodily injury.
Avoid quick stops, excessive force, and uneven floor surfaces when moving
the laminator on a cart or stand.
Do not defeat or remove electrical and mechanical safety equipment such as
interlocks, shields and guards.
Do not insert objects unsuitable for lamination or expose the equipment to
liquids.
ELECTRICAL
The laminator should be connected only to a source of power as indicated in
these instructions and on the serial plate located on the rear of the laminator.
Contact an electrician should the attachment plug provided with the
laminator not match the receptacles at your location.
Disconnect the attachment plug from the receptacle to which it is connected
and maintain the power supply cord in your possession while moving the
laminator.
Disconnect the attachment plug from the receptacle when the laminator is
not used for extended periods of time.
Do not operate the laminator with a damaged power supply cord or
attachment plug, upon occurrence of a malfunction, or after the laminator
has been damaged. Contact GBC’s Technical Service Department or your
dealer/distributor for assistance.
Observe the marked electrical rating on the equipment to avoid overloading
the branch circuit (receptacle) to which the laminator is connected.
Disconnect the attachment plug from the receptacle and maintain the power
supply cord in your possession when replacing the line fuse. The fuse holder