Dual Extruder Printers - 2in1 Dual
1. Make sure when using the 2in1 dual
extruder to insert the le (extruder
#1) filament first unl it comes out the
hotend.
2. Then insert the right (extruder #2)
filament unl you feel when it hits the
first filament and pull back about
5mm.
3. Babystep and bed level the printer just
like a single extruder.
The 2in1 dual extruder uses similar settings as the single
extruder and does not require independent adjustments of
the hotend height. Make sure to update your slicing
settings.
Pg 12
the
Thermistor Set Screw
Heater Cartridge Set Screw
To Next Page
Loading...
