gCreate gMax 2 PRO - Stepper Drivers; Adjustment and Replacement

Water Soluable (PVA) Support Material
1. Follow the previous example sengs for Dual Extrusion
prinng.
2. Make sure to increase the interferance layer density of
the PVA support material to 100% and the distance from
the part to zero. Below are addional sengs to keep an
eye out for.
You can use the gMax 2 PRO dual extruder to print
your part out of one material and the support
material out of water soluable PLA material. This
support can then be dissolved away in water for a
cleaner surface finish.
PLA 3D Print
PVA Support
Simplify 3D Support Sengs
Cura Support Sengs
P
1
. F
o
p
r
2
. M
a
th
P
Solid PVA Top Layer
S
Simplify3D
Pg 14