2Ć4
GFKĆ1029BLogicmaster 90Ć30 and Logicmaster 90Ć70 TCP/IPĆEthernet User's Manual Supplement-April 1996
This procedure assumes that you will be using an NDIS driver. If you are using ODI, the
procedure may vary. The following steps should be completed in order.
1. Make a bootable floppy disk.
2. Save your existing AUTOEXEC.BAT and CONFIG.SYS files.
3. If you will be using Direct Ethernet connection, install the PC Ethernet adapter in
your PC.
4. Make a copy of the Beame & Whiteside Preliminary Worksheet and fill it out. (A
partially filled out worksheet is shown in Appendix A.) You will need to determine:
IRQ Address
I/O Address
Shared memory (Yes or No - If yes, you will need the start address.)
Buffer space 10,000 for Logicmaster 90 software
Software interrupt vector
For requirements specific to SLIP, refer to page 2Ć7.
5. If your PC Ethernet adapter has installation software with it, run the INSTALL
program.
6. Continue with installation:
D. If you are using 90Ć70 and this is an initial installation on this PC, continue with
the Quick Start installation in Appendix A.
E. If this installation is 90Ć30 and you will use SLIP, continue on page 2Ć7.
F. Otherwise, continue on page 2Ć5.
To Next Page
Loading...
Need help?
General
