GE Profile 22 - TEMPERATURE CONTROLS AND OPERATION; Turning the Cooling System Off; Glass Touch Model Operation; Adjusting Refrigerator and Freezer Temperatures

35
SafetyInstructions OperatingInstructions InstallationInstructions TroubleshootingTips ConsumerSupport
ABOUT THE TEMPERATURE CONTROLS
Torunyourrefrigerator:
• Connect the power supply.
• Select the temperature control.
• To adjust the temperature of your refrigerator in
accordance with the amount of your food and
climate of your city. The temperature controls are
preset in the factory at 3˚C (37˚F) for the refrigerator
compartment and -18˚C (0˚F) for the freezer
compartment.
Allow24hoursforthetemperaturetostabilizetothe
presetrecommendedsettings.
Refrigerator temperatures can be adjusted between 1˚C
and 7˚C (34˚F to 44˚F), and the freezer temperatures can
be adjusted between -21˚C and -14˚C (-6˚F to 6˚F).
Note:The refrigerator is shipped with protective lm
covering the temperature controls. If this lm was not
removed during installation, remove it now.
TochangetheRefrigeratorroomtemperature:
To adjust the Actual Temp Control temperature, rst
press the Freezer (Temperature) or Refrigerator
(Temperature) button. Then press WARMER(+) or
COLDER(-) to increase or decrease temperature to the
desired setting. Once the desired temperature has been
set, the temperature display will return to the actual
refrigerator and freezer temperatures after 5 seconds.
Several adjustments may be required. Each time you
adjust the control, allow 24 hours for the refrigerator to
reach the temperature you have set. The temperature
controls can display both the SET temperature as
well as the actual temperature in the refrigerator and
freezer. The actual temperature may vary slightly
from the temperature based on usage and operating
environment.
Turningthecoolingsystemo
Setting either or both controls to 0 stops cooling in both
the freezer and refrigerator compartments, but does not
shut o electrical power to the refrigerator.
When the unit is turned back on, it will take up to 24
hours to stabilize.
ModelswithGlasstouch
This control is touch sensitive, you do not need to push
the button but touch to activate the function.
To adjust the temperature use SETTEMP to activate the
function, touch the button the necessary times to set
either refrigerator or freezer temperature, then use (+) or
(-) buttons to increase o decrease the temperature value.
To see the refrigerator actual temperature touch the SET
TEMP button during 5 seconds.
Note: Allow 24 hours for the temperature to stabilize to
the preset recommended settings.