EasyManua.ls Logo

GE Profile 22 - About the Refrigerator Doors

GE Profile 22
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
39
SafetyInstructions OperatingInstructions InstallationInstructions TroubleshootingTips ConsumerSupport
1. If you are replacing a SmartWater cartridge with
an adapter, it must be removed before installing
the cartridge. To remove the adapter, turn it to the
left about 1/4 turn. If you are replacing a Water
byCulligan cartridge, leave the adapter in place.
This adapter will stay in the refrigerator when you
replace future cartridges.
2. Apply the month and year sticker to the new
cartridge to remind you to replace the lter in six
months.
3. Fill the replacement cartridge with water from
the tap to allow for better ow from the dispenser
immediately after installation.
4. Line up the arrow on the cartridge and the cartridge
holder. Place the top of the new cartridge up inside
the holder. Donotpushit into the holder.
5. Slowly turn it to the right until the lter cartridge
stops. Donotovertighten. As you turn the cartridge,
it will automatically raise itself into position. The
cartridge will move about 1/2 turn.
6. Run water from the dispenser for 3 minutes (about 6
liters) to clean the system and prevent sputtering.
7. Press and hold the RESETFILTER pad (on some
models) on the dispenser for 3 seconds.
FilterBypassPlug
You must use the lter bypass plug when a replacement
lter cartridge is not available. The dispenser and the
icemaker will not operate without the lter or lter
bypass plug.
To use the lter bypass plug on WaterbyCulligan
models, you must rst remove the lter adapter from the
cartridge holder by turning it to the left.
Warning:Connect to potable water supply only.
ABOUT THE REFRIGERATOR DOORS
The refrigerator doors may feel dierent than the ones
you are used to. The special door opening/closing
feature makes sure the doors close all the way and are
securely sealed. When opening and closing the door you
will notice a stop position. If the door is opened past this
stop point, the door will remain open to allow you to
load and unload food more easily. When the door is only
partially open, it will automatically close. When the door
is only partially open, it will automatically close. Beyond
this stop the door will stay open.
Nota: The resistance you feel at the stop position will be
reduced as the door is loaded with food.