36
Inserting a Pause in the Dialing Sequence
of a Stored Number
If a pause is needed to wait for a dial or access tone,
press the # button to insert a delay in dialing sequence
of a stored number (for example, after you dial 9 for
an outside line, or to wait for a computer access tone).
Pause shows in the display as a P, and each pause
counts as one digit in the dialing sequence.
Changing a Stored Number
1. Repeat steps 1 through 7 in Storing a Name and
Number in Memory.
2. Press the mem button, and REPLACE MEMO? shows in
the display.
3. Press the mem button to store the number. You will
hear a confirmation tone.
Reviewing and Deleting Stored Numbers
1. To review stored numbers, press the mem button,
and use the CID/vol (5 or 6) button to scroll to the
memory location, or press the corresponding number
key for a desired memory location (0-9).
To Next Page
Loading...
