GE 2-9451 - Page 37

37
PROGRAMMING THE EXTENSION NUMBER
The line 3 and line 4 extension numbers are used for some of the
advanced functions utilized by the system.
1. Press PROGRAM.
2. Press the line you want to set.
3. Enter the 4-digit extension number (0-9 for each digit).
4. Press # to confirm.
PROGRAMMING A PAGE GROUP
Your station can be assigned to one of a total of 9 groups for the paging
functions. Each station in a page group must be programmed as follows:
1. Press PROGRAM.
2. Press PAGE. PAGE shows on the display.
3. Press the page group number (0-9) you want to assign to your station.
4. Press # to confirm.
NOTE: The default is 0 for no page group assignment.
PROGRAMMING THE PULSE/TONE MODE
1. Press PROGRAM.
2. Press the asterisk (*) key.
3. Press 0 for tone, 1 for pulse.
4. Press # to confirm.