6
Direct Code Entry
1. Press and hold the SETUP button until the red
indicator stays on, then release the SETUP button.
2. Press and release the desired device button (TV,
DVR, etc.). The red indicator blinks, then stays lit.
3. Enter the 4-digit code from the code tables (on
separate sheet). Note: after a valid
code entry, the red indicator turns off.
For an invalid code, the red indicator
flashes.
4. With your device on, press ON/OFF.
If the device turns off, no further
programming is required. Note: If
some buttons do not operate your
equipment, try one of the other codes
for your brand.
Write your codes down here for easy reference later.
Device Device stored Code
TV TV
DVD/DVR
CBL/SAT
To Next Page
Loading...
