Replacing the light bulbs,
Turning the control to the 0 (offl position does not remove power to the light circuit.
Refrigerator Lights (onsomemodels)
ik CAUTION:u Ubu)b n oy
be hot.
0 Unplugthe refrigerator.
0 To remove the light shield,grasp the
shieldat the back and pull out to release
the tabs at the back.
Rotatethe shield down and then forward
to releasethe tabs at the front of the
shield.
After replacing with an appliance bulb of
the same or lower wattage, replace the
shield.
Plugthe refrigerator back in.
NOTE:Appliance bulbs may be ordered from
GEPartsand Accessories,800.626.2002.
LED Lighting - Module (on some models)
LED Lighting - Individual (on some models)
LEDlighting will need to be replaced by an
authorized technician.
Call!.800.432.2737 in the United States.In
Canada,call 1.800.561.3344
Light
Shield
Appearance may vary
Freezer Light (on some models)
A CAUTION:Lightbulbs may
be hot.
Unplugthe refrigerator.
Removethe freezer basket for access.
Thebulb is located at the rear of the
freezer inside a light shield.
O Toremove, grasp the shield at the top
and pull out to releasethe tabs at the
bottom.
After replacing with an appliance bulb of
the same or lowerwattage, replace the
shieldand freezer basket.
Plugthe refrigerator back in.
15
To Next Page
Loading...
Need help?
General
