Installation Instructions
INSTALLING THE REFRIGERATOR (cont.)
LEVEL THE REFRIGERATOR
The leveling legs have 2 purposes:
1) Leveling legs adjust so the refrigerator is
firmly positioned on the floor and does not
wobble.
21 Leveling legs serve as a stabilizing brake to
hold the refrigerator securely in position
during operation and cleaning. The leveling
legs also prevent the refrigerator from
tipping.
r_ Remove the grille by removing the two Phillips-
head screws.
r_ Turn the leveling legs clockwise to raise the
refrigerator, counterclockwise to lower it.
A CAUTION: Toavoidpossible
personal injuryor propertydamage, the
levelinglegsmust be firmlytouching
the floor.
r_ Replace the base grille by inserting the two
Phillips-head screws.
[_ SET THE CONTROLS
Set the controls to the recommended setting.
5 5
I. co, ooo.T.O osl
©
0 _F IS RECOMMENDED 37 °F IS RECOMMENDED
I'_ REMOVE PACKAGING START
ICEMAKER (icemaker models)
A) Remove all tape, foam and protective
packing from shelves and drawers.
B) Remove the tie downs from the freezer
baskets.
C) Place half width basket onto drawer slides.
See About the freezer section for
instructions.
Set the icemaker power switch to the I Ion}
position. The icemaker will not begin to operate
until it reaches its operating temperature of
15°F (-9°C) or below. It will then begin operation
automatically. It will take 2-3 days to fill the
ice bin.
NOTE:
In lower water pressure conditions, the water
valve may turn on up to 3 times to deliver
enough water to the icemaker.
25
To Next Page
Loading...
Need help?
General
