4
About the controls with temperature settings.
The temperature controls are preset in the factory at 3°C for the refrigerator compartment and
-18°C for the freezer compartment. Allow 24 hours for the temperature to stabilize to the preset
recommended settings.
The temperature controls can display both the SET temperature as well as the actual
temperature in the refrigerator and freezer. The actual temperature may vary slightly from
the SET temperature based on usage and operating environment.
Setting either or both controls to OFF stops cooling in both the freezer and refrigerator
compartments, but does not shut off electrical power to the refrigerator.
For Controls-on-the-Door Models:
To change the temperature, press and release the
WARMER or COLDER pad. The ACTUAL TEMP light
will come on and the display will show the actual
temperature. To change the temperature, tap either
the WARMER or COLDER pad until the desired
temperature is displayed.
This control only displays one compartment
temperature at a time. To display or change the
other compartment temperature, press the FREEZER
or REFRIGERATOR pad, then follow above “To change
the temperature” instruction.
For Controls Inside the Refrigerator:
Opening the door displays the actual temperature.
To change the temperature, press either the WARMER
or COLDER touch pads until the desired temperature is
displayed.
Once the desired temperature has been set,
the temperature display will return to the actual
refrigerator and freezer temperatures after 5 seconds.
Several adjustments may be required.
Each time you adjust controls, allow 24 hours for the
refrigerator to reach the temperature you have set.
To turn the cooling system off, tap the WARMER pad for
either the refrigerator or the freezer until the display
shows OFF. To turn the unit back on, press the COLDER
pad for either the refrigerator or freezer. Then press
the COLDER pad again and it will go to the preset points
of -18°C for the freezer and 3°C for the refrigerator.
Setting either or both controls to OFF stops cooling in
both the freezer and refrigerator compartments, but
does not shut off electrical power to the refrigerator.
Changing the Temperature
NOTE: The refrigerator is shipped with protective film covering the temperature controls.
If this film was not removed during installation, remove it now.
(on some models)
(on some models)
To Next Page
Loading...
Need help?
General
