GE 23598 - Remote Access Commands

2
To access your answerer:
1. Call your telephone number.
2. After you hear the beep that follows the greeting, enter your 3-digit security code.
The unit conrms your code with a double beep and plays the remote menu. IF the
wrong security code is entered the unit beeps three times and allows for correct
code to be entered.
NOTE: To bypass the greeting, you can enter your -digit security
code any time while the greeting is playing.
The unit waits for a remote command for 20 seconds after the correct security code
has been entered. Menu selections can be made while the menu is playing.
NOTE: The unit answers on the 10th ring when it is turned off or the
memory is full. To access the answerer, enter the -digit security
code after the beep. If memory is full, play messages and erase
some of them to restore memory.
NOTE: After the unit plays the remote menu, it waits 20 seconds for
a command, then disconnects.
Remote Access Commands
Play new message 1
Play all messages 2
Repeat messages (
during message playback) 5
Play previous message (
during message playback) 6
Skip to next message (
during message playback) 7
Erase message (
during message playback) 0
Stop playback (
during message playback) 4
Turn answerer on/off 3
End call 4