7
Direct Code Entry
1. Press and hold the SETUP button until the red
indicator stays on, then release the SETUP button.
2. Press and release the desired mode button (TV,
DVD, etc.). The red indicator blinks, then stays lit.
3. Enter the 4 digit code from the code tables (on
separate sheet). Note: after a valid code entry, the
red indicator turns off. For an invalid code, the red
indicator ashes.
4. With your device on, press CHANNEL UP. If
the device responds, no further programming is
required. Note: If some buttons do not operate your
equipment, try one of the other codes for your brand.
Write your codes down here for easy reference later.
Device Device stored Code
TV TV
DVD
CBL/SAT
DVR/AUX
To Next Page
Loading...
