11
Using Your Remote
Master Volume Feature
The Master Volume Feature allows you to select a
single device (TV or audio receiver) that the volume
control always controls. For example, the remote can
be in TV mode while the volume buttons control the
volume on your audio receiver instead of your TV.
Enabling the Master Volume Feature
1. Press and hold the Setup button
until the red indicator stays on
(approximately 2 seconds) and then
release the button.
2. Press and release desired device
button (TV, cbl, dvd, aux) for the device
you wish to control the volume.
3. Press and release the
OK button.
4. Press and release the VOL
button.
The red indicator will blink twice and
then go off.
Disabling the Master Volume Feature
1. Press and hold the Setup button
until the red indicator stays on
(approximately 2 seconds) and then
release the button.
2. Press and release the device
button (TV, cbl, dvd, aux) which is
programmed to control the Master
Volume Feature.
3. Press and release the
OK button.
4. Press and release the VOL
button.
The red indicator light will blink twice
and go off.
To Next Page
Loading...
