12
Code Identification
1. Press and hold down the Setup button
on the remote until the red light on
the remote control turns on. Release
the Setup button. The red light will
remain on.
2. Press and release the desired device
button (TV, cbl, dvd, aux) you would like
the code for.
3. Press and release Enter button.
4. Press and release the #1 button.
Count the number of times the remote
light flashes. This is the number
corresponding to the first digit of the
code. Repeat the process by pressing
the #2, #3 and #4 buttons for the
remaining digits.
5. Press and release Enter button to exit
this mode.
Reset to Factory Settings
1. Press and hold the Setup button
until the red indicator stays on
(approximately 2 seconds) and then
release the button.
2. Press and release the OK button.
3. Press and release the number #0 button.
The red indicator light will flash twice.
Using Your Remote