Need help?Do you have a question about the GE 34140 and is the answer not in the manual?
Never touch power lines, inspect site carefully, maintain distance from power lines, and avoid windy conditions.
Contact a professional installer if unsure about safe installation and grounding procedures.
Select a location far from power lines, maintaining at least twice the combined height.
Determine broadcast tower locations using online resources like www.antennaweb.org.
Verify installation complies with local building and electrical codes.
Illustrates an outdoor or attic wall mounting option for the antenna.
Shows an outdoor mounting option under the roof eaves.
Depicts an indoor wall mounting option for the antenna.
Lists all components included with the GE 34140 Indoor/Outdoor Antenna.
Rotate the antenna base into an upright position for assembly.
Remove the thumb screw and mounting bracket from the antenna base.
Attach the mounting bracket to the antenna using the M5 bolt.
Attach the antenna to the antenna base using the thumb screw.
Choose and place the antenna in the desired location using preferred mounting method.
Connect the coax cable from the antenna to your TV.
Tighten the screw to secure the antenna and use screw covers.
Connect one end of the coax cable to the antenna and the other to a 75 ohm grounding block.
Prepare a pre-built coax cable by cutting slits in the rubber boot for proper attachment.
Use a second coax cable to connect the grounding block to your TV.
Connect grounding wire to the 75 ohm grounding block and an acceptable building ground.
Aim antenna in different directions and rescan channels for best reception.
Mount antenna as high as possible and point towards broadcast towers.
Visit www.antennaweb.org or www.dtv.gov for reception maps and tower locations.
Carefully inspect the area for power lines and reverse installation steps for removal.
To Next Page
General
