GE 36 - Page 18

18
Anti-Tip Bracket Installation
36” All-Refrigerator and All-Freezer Units
Anti-tip
bracket
installation
(cont.)
Remove Grilles for Access to Anti-Tip Locking
Hooks
Fresh Food Unit
2SHQWKHDFFHVVGRRU
• Remove the 4 screws from the grille.
• Pull the bottom of the grille forward, down
and out to remove.
Freezer Unit
2SHQWKHDFFHVVGRRU
• Remove the 4 screws from the grille.
• Pull the bottom of the grille forward, down
and out to remove.
Power Cord
Locate the power cord inside the left cavity.
If it has not been adjusted so the plug is easily
accessible, do so now.
Move Unit into Final Position
• Move refrigerator toward its final installed
location. Align the tabs on the wall bracket
with the openings in the back of the unit.
• The unit has “L” bolts in the upper left and right
corners inside of the access compartment.
These bolts will interlock with the wall bracket
and secure the unit using the washers and hair
pin cotters in the hardware kit once the unit
has been leveled and is in the final position.