GE 7-4870 - Page 3

Turn
the Radio On
®
Press
(auJ
or
key,
or
Ciel
iale]
Recall
keys.
Piae wd
Eig
ia
ni
FM
AM
RECALL
SNOOZ
The radio
will
automatically
tune to the
last
AM
or
FM
station
played,
or station in
memory,
the
DIGITAL
DISPLAY
(2)
will
show the
Frequency
(call
numbers)
for 5
seconds,
then return to
show time
(unless
DISPLAY INDICATOR
(4)
is
in
RADIO
position).
Adjust
VOLUME
for
your
preferred
listening
level.
Tune the
Radio
e
Press
DISPLAY
key (5)
until DISPLAY
INDICATOR
(4)
reaches RADIO
position.
Pisa
s4
pag
eet
DISPLAY
KEY
(5)
DISPLAY
POSITION INDICATOR
(4)
@
“SCAN THE
BAND”:
Use
-
[FAST]
-
(8)
to tune in
other stations. The
station
frequency
will
read
out
in
the
display
as
you
tune
up
or down
the radio
bands.
Release the
key
when
you
hear a
desired station or reach the
exact
frequency
of
your
favorite station.
Pressing
or
(EwD/al
only
will
change
the
DIGITAL
DISPLAY
(2)
at a
slow rate. To
tune at a fast
rate,
press
[FAST]
along
with
or
@
Press
[DISPLAY]
key (5)
to return
DISPLAY
INDICATOR
(4)
to TIME
LOCK
position.
*
To TURN
THE
RADIO
OFF,
press
the
key
(7).
NOTE: Ifthe or
key
is held
down,
the scan will
stop
at
band ends
(AM530
—
1610,
FM88.{
—
107.9).
If
the
key
is released then
pressed
again,
the scan
will
start at
the
opposite
band end.
¢
AM
Stations
are
currently
broadcast on
frequencies
between and [1610] KHz at
10 KHz
intervals,
therefore end with a
“zero”,
e.g.:
530,
540,
550...
1590, 1600,
1610.
¢
FM
Stations are
broadcast on
frequencies
between and
MHz at .2MHz
intervals,
and,
therefore,
always
end with
an “odd’
number,
e.g.:
88.1.
88.3,
88.5...
107.5, 107.7,
107.9.
¢
You can
tune to
any
AM
or
FM
station
when the DISPLAY
INDICATOR
(4)
is in TIME or
WAKE 1
&
2
positions.
Pressing
the
or
key
will
automatically
set the DISPLAY
INDICATOR
(4)
to the
RADIO
position.
The
Digital Display (2)
will
show
the Station
Frequency
for 5
seconds,
then
return to the
display
shown on DISPLAY
INDICATOR.
®
FINE
TUNING,
as
you
would
conventional radios to
pin point
the station
frequency
is not
necessary.
This
radio
tunes the exact
radio station
frequency
as indicated
by
the DIGITAL
DISPLAY
(2)
readout.
To Store a
Station in
Memory
Your
radio
can
be
programmed
to
instantly
recall
4
of
your
favorite AM or FM
stations.
You can store
any
combination of
FM
or AM
stations
in
the
4
memory
locations
—
all
AM
or
all FM:
or
2 AM
and 2
FM,
etc.
When
storing
a
station
you
must
press
key
first,
followed
by
the
memory
number.
*
Press
key (5)
to set
DISPLAY
INDICATOR
(4)
to
RADIO.
¢
Tune
the radio to
a desired AM or FM
station.
e
Press & release
key (9)
then
[1]
key.
Station is now
“stored” in
memory
#1.
e
Tune
radio to a
different
station and
press
&
release
then
key.
In
a
similar
manner,
load
&
memories.
®
Press
key (5)
to set
DISPLAY
INDICATOR
(4}
to TIME
LOCK
position.
NOTE: The
station
memory
numbers
(1],[2].[3],
or
keys
must be
pressed
within
5
seconds after
pressing
the
key.
You
can
press
any memory
key,
in
any
order and
change
the
memory
whenever
you
choose.
To
Recall a
Station
—
‘‘One
Button
Recall’’
¢
To listen to
stations stored in
‘memory’, simply press
any key
L4]thru
L4|.
The radio
automatically
tunes to
the
AM
or FM
station
stored
in
the
memory
location
you
selected.
®
The DIGITAL
DISPLAY
(2)
will
show the
frequency
for 5 seconds or
continuously
if
DISPLAY
INDICATOR
(4)
is in
RADIO
position.
NOTE:
Remember,
when
storing
a
station
you
must
press
&
release
key
first,
followed
by
the station
memory
number
(1-4)
key.
To recall
a
station,
merely press
the
station
memory (1-4) key.
To Select Wake
Up Time(s)
You can
program
two different wake
up
times into the
memory:
WAKE
#1
®
Press
key (5)
to set DISPLAY
INDICATOR
(4)
to
WAKE 1
position.
®
Slide
WAKE 1
SELECTOR
(14)
to MUSIC or MUSIC/ALARM.
©
Enter desired AM
or
PM
Wake
Up
Time
using
orlEWD‘a)
keys (Simultaneously
pressing
key
will
change
the DIGITAL DISPLAY at a
fast
rate).
¢
Press
key (5)
to return DISPLAY
INDICATOR
(4)
to
TIME LOCK
position.
MUSIC/
t-
WAKE
-2
e
e
OFF
e
--
SET—
TIME
-
Lock
-
RADIO
WAKE
SELECTORS
DISPLAY
POSITION INDICATOR
(4)
WAKE
#2
*
Press
key (5)
to set
FUNCTION INDICATOR
(4)
to WAKE
2
position,
®
Slide WAKE 2
SELECTOR
(14)
to MUSIC or MUSIC/ALARM
position.
@
Enter desired AM
or
PM
Wake
Up
Time
using
or
keys.
Simultaneous-
ly
pressing key
will advance the DIGITAL DISPLAY at a fast
rate.
Press
key (5)
to return DISPLAY INDICATOR
(4)
to TIME LOCK
position.
5