GE AF-600 FP Series User Manual (English)

Other manuals for GE AF-600 FP Series

Manual7 pages

Design And Installation Guide121 pages

Questions and Answers:

J
Jesse WilliamsAug 12, 2025
What to do if the GE DC Drives display is dark?
- J
  Jason LeeAug 12, 2025
  If the GE DC Drives display is dark, start by checking the input power source. Also, inspect the fuses for any breaks or if the circuit breaker has tripped and follow the recommendations provided. Ensure that the terminals are wired properly to avoid a shortcut on control voltage. If none of these steps work, the display (keypad) might be defective and needs replacement, or there may be an internal voltage supply fault, requiring you to contact the supplier.
T
Thomas BrownAug 20, 2025
How to fix a GE DC Drives display with no function?
- R
  Rhonda RuizAug 20, 2025
  To fix a GE DC Drives display with no function, check the input power source first. Then, check for any blown fuses or tripped circuit breakers and follow the recommendations provided. Also, verify that there is power to the keypad; if not, replace the faulty keypad or connection cable. Ensure correct wiring of the terminals to prevent control voltage shortcuts. If the issue persists, adjust the contrast by pressing [Status] + [?]/[?]. If still not working, the display may be defective, or there could be an internal voltage supply fault, requiring you to contact the supplier.
D
Dr. Adam SmithAug 27, 2025
Why is my GE DC Drives display flickering?
- J
  Jason GoodAug 27, 2025
  An intermittent display on your GE DC Drives could be due to an overloaded power supply caused by improper control wiring or a fault within the frequency converter. If the display stays lit, check the control wiring for shorts or incorrect connections. If the display continues to cut out, follow the procedure for a dark display.
G
grosssamanthaSep 3, 2025
How to adjust contrast on GE DC Drives if the display is dark?
- J
  John CurrySep 3, 2025
  If the GE DC Drives display is dark due to a wrong contrast setting, press [Status] + [?]/[?] to adjust the contrast.