3.4 Electrical Installation
This section contains detailed instructions for wiring the drive. The following tasks are described.
•
Wiring the motor to the drive output terminals
•
Wiring the AC line power to the drive input terminals
•
Connecting control and serial communication wiring
•
After power has been applied, checking input and motor power; programming control terminals for their intended
functions
Illustration 3.4 Basic Wiring Schematic Drawing.
A=Analog, D=Digital
Terminal 37 is used for Safe Stop. For Safe Stop installation instructions, refer to the Design Guide.
*The brake chopper factory option must be ordered to use dynamic braking resistors.
**This is available when ordering the brake chopper option on unit size 23 and above drives.
Installation AF-650 GP Quick Guide
DET-759A 5
3
To Next Page
Loading...
