Aboutthe controlsonthe air conditionermmodels with touchpads.
Features and appearance will vary.
Coolon
Fanon
Energy
Saveroi
Air ConditionerControls Remote Control
Controls
O ON/OFF Pad
Turns air conditioner on and off.
oisplav
Shows the set temi)eramre or time remaining
on tilller.
O MODE
Use to set tile air conditioner to COOLor
FAN mode.
Increase •/Decrease • Pads
Use to set temperature when in COOLmode.
O FAN Pad
Use to set the _im speed to LOW(F1), MED (F2)
or HIGH (F3).
O ENERGYSAVER(on some models)
Controls tile tim.
0]_-The tim and c()mi)ressor c)'cle on and
off. This results in wider \_riafions of room
temperature and humidiP,'. Nommllv used
when tile room is tmoccuI)ied. NOTE: Thefan
will continue to run for a short timeafter the
compressorcyclesoff
OFF Tile tim rtms all tile time, while tile
COIIII)I'eSSOI" cycles on [In(1 o]C{ ',
This t_'atm'e must be set at OFFin order to use
the tim settings (on the mode control).
NOTE:Onsome models, theENERGYSAVER feature
cannotbe seton the air cond/tione_Itmust beset uslhg
the remotecontrol
O CIRCULAIRE(onsomemodels)
FOF (onfint/otls side-to-side air circulation
(cool settings only), set the Circulaire switch
to ON.
Dn" fixed side-to-side air direction, turn ON
until the desired air direction is obtained,
then turn it OFK
O TIMERPad
0/_-_ hen tile air conditioner is off, it can be
set to automatically come on in 1 to ] 2 ho/u_
or 1 to 24 hom_ (depending on model) at its
previous setting. Each touch of tile TIMER pad
or tile INCREASE•/DECREASE• pads
(del)ending on model) will set tile diner
in hom_.
OlaF _&l/en the air conditioner is on, it can be
set to automatically mm off in 1 to 12 hom_ or
1 to 24 hems (depending on model). Each
touch of tile TIMER pad or tile INCREASE• /
DECREASE• pads (depending on model) will
set tile timer in hom_.
Tocancel the tinier, press tile TIMER pad until
tile display time disappears.
Remote Control Signal Receiver
4
Remote Control
To ensure proper operation, aim tile remote
control at tile signal receiver on tile air
conditioner.
Tile remote control signal has a range of
up to 21 feet.
Make sm'e nothing is between tile air conditioner
and the remote control that could block the
signal.
Make sm'e batteries are fl'esh and installed
correctly as indicated on tile remote control.
To Next Page
Loading...
Need help?
General
