Aboutthecontrolsontheair conditioner--modelswith touchpads.
Appearance may vary.
]
Air ConditionerControls
Lightsbesidethetouchpadsonthe airconditioner
controlpanelindicatethe selectedsettings.
RemoteControl
Controls
Whenthe air conditioneristurnedon,it will
automaticallystartin thesettinglastused.
O ON/ITOPo o
Turn,_ air c nditi net on and off.
Display
_k MODE
r On tile remote control, rise to set tile air
conditioner to COOL or FANmode.
On tile air conditioner controls, use to set
COOLor FANmode at HIGH,MED or LOW
tim speed. Indicator lights on tile air
conditioner controls will show tile mode
and tim speed selected.
O TEMP Increase •/Decrease • Pads
Use to set temperature when in COOL
illode.
O an Speeds (Remote control only)
Use to set tile fiul speed at LOVV,MEDor
HIGH.
O TIMER
ON--\,_q/ell tile air conditioner is off, it
can be set to automatically mrn on in half
an horn" to 24 hours at its previous setting.
Each touch will set tile time in half horn's
up to lO and then in hem5 up to 24.
To cancel (CI,) tile On Timer press tile
ONpad again.
OFF--X&]/en the air conditioner is on, it
can be set to automatically turn off in half
an horn" to 24 hom_. Each touch will set
tile time in haft hom_ up to 10 and then
in hom_ up to 24.
To cancel (CI,) tile OffTimer press tile
OFFpad again.
To cancel tile timex; press tile Omor OFF
pads/mtil tile display time disappears.
O SLEEP
Press to set tile air conditioner to run for
S hom_ before it automatically returns to
tile previous setting.
X_]mn tile sleep timer is set, tile set
temperature will automatically increase
2°F alter tile second horn" then l °F each
ho/lI" over tile Ilext two NO/IIN.
To cancel tile sleep mode, press tile MODE
pad or tile SLEEPpada second tilne.
O RemoteControlSignal Receiver
4
Remote Control
[] To ensure proper operation, aim tile
remote control at tile signal receixer
on tile air condifione_:
[] Tile remote control si_mal has a range of
up to 21 feet.
[] Make sure nothing is between tile air
conditioner and tile remote control that
could block the signal.
[] Make sure batteries are fl'esh and installed
correcflx_see tile Care and gleaning section.
To Next Page
Loading...
