EasyManua.ls Logo

GE AKLK08 B - User Manual

GE AKLK08 B
2 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
SAFETY INFORMATION
The image shown here is for illustrative purposes only and may be subject to change.
The actualdescriptions of control panel and their locations may vary depending on the model.
The remote control vary depend of
model: The buttons on remote control
may have a diff erent name or location
than the remote control shows in this
manual.
CONTROLS
CARE AND CLEANING
USING THE AIR CONDITIONER
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
• Accessory type appearance and quantity may vary depending on the model.
804106507
(Batteries Not Included)

Questions and Answers

  • E
    Erica PriceAug 7, 2025
    What to do if my GE Air Conditioner does not start?
    • E
      Emily HopkinsAug 7, 2025
      If your GE Air Conditioner doesn't start, several factors could be at play. First, ensure the air conditioner is fully plugged into the outlet. Check your house's fuse or circuit breaker box, replacing the fuse or resetting the breaker if necessary. If there was a power failure, the unit should restart automatically with your last settings once power returns. Note that there's a protective 3-minute delay to prevent compressor overload, so normal cooling might not begin immediately after turning it back on. Also, check the current interrupter device; press the RESET button on the power cord plug. If the RESET button doesn't stay engaged, stop using the air conditioner and contact a qualified technician.
  • R
    Renee TorresAug 12, 2025
    Why is my GE Air Conditioner not cooling properly?
    • S
      Susan BlackAug 12, 2025
      If your GE Air Conditioner isn't cooling as expected, several things could be happening. Make sure that curtains, blinds, or furniture aren't blocking the front of the unit, restricting airflow. If you have a model with touch pads, ensure the temperature is correctly set by pressing the Decrease – pad in Cool mode. For models with control knobs, turn the temperature knob to a higher number. A dirty air filter can also cause this issue, so clean the filter at least every 30 days. If the room was hot when you turned on the unit, allow time for it to cool down. Check for open furnace registers and cold air returns where cold air might be escaping. Finally, inspect for ice buildup on the cooling coils, which is addressed in the 'Air conditioner freezing up' section.
  • J
    Julian WaltersAug 16, 2025
    What to do if my GE AKLK08 B is freezing up?
    • J
      jameshensonAug 16, 2025
      If your GE Air Conditioner is freezing up, it's likely that ice is blocking the airflow, preventing the unit from cooling the room. For models with control knobs, set the mode control to High Fan or High Cool with the Temp at 1 or 2. If you have a model with touch pads, set the controls to High Fan or High Cool and adjust the thermostat to a higher temperature.
  • C
    Connie SloanAug 20, 2025
    What to do if water drips indoors from my GE Air Conditioner?
    • C
      Cynthia DavisAug 20, 2025
      If water is dripping indoors from your GE Air Conditioner, it may not be tilted correctly. Ensure the air conditioner slants slightly from the case front to the rear to allow for proper water disposal.
  • A
    Aaron MccormickAug 25, 2025
    Why is my GE AKLK08 B dripping water outside?
    • S
      steven82Aug 26, 2025
      If your GE Air Conditioner is dripping water outside, this is normal during hot, humid weather.
  • J
    Jorge WoodsAug 29, 2025
    How to fix a GE AKLK08 B remote control that is not working?
    • P
      Patrick RodriguezAug 29, 2025
      If your GE Air Conditioner remote control isn't working, first check the batteries' position, ensuring they are inserted in the correct (+) and (–) direction. If they are correctly inserted, the batteries may be dead and need replacing.
  • J
    Jeremy AguilarSep 2, 2025
    Why does water collect in the base pan of my GE AKLK08 B Air Conditioner?
    • V
      valenzuelajerrySep 2, 2025
      Water collecting in the base pan of your GE Air Conditioner is normal. It happens because moisture is being removed from the air and draining into the pan. This is normal for a short period in areas with low humidity and normal for a longer period in very humid areas.

GE AKLK08 B Specifications

General IconGeneral
Energy Efficiency Ratio (EER)12.1
Voltage115V
Weight47 lbs
Noise Level52 dB
Operating Voltage115 V
Operating Frequency60 Hz
Noise Level (High)52 dB
Cooling Capacity8000 BTU
TypeWindow

Related product manuals