GE AST05 - Pads

Aboutthe controlsonthe air conditionermmodels with touchpads.
Features and appearance will vary.
COOLOn
ENE£GY
SAVE£ On
SLEEPOn
Air ConditionerControls Remote Control
4
_k On/Off
WTurns air conditioner on and oil
@ Display
@
Displays the set temperature or time
remaining on fimei:
Mode
Use to set tile air conditioner to Cool or Fan
mode.
O Increase •/Decrease • Pads
Use to set temperature when in Cool mode.
0 Fan
Use to set the tim speed at tow, Medor High.
O Circulaire(onsomemodels)
Turn on to provide continuous side-to-side
air circulation.
For fixed side-to-side air direction, turn On
until the desired air direction is obtained,
then turn it 0_.
Energy Saver-Controls the tim.
0n--The fiIIl and compressor cycle on and
off. This results in wider \miations of room
temperature and humidit,i. Nora/ally used
when the room is unoccupied. Note: The fan
will continue to run for a short time after the
compressor cycles off
0ffJThe liln i'tlns all the time, while the
COlIlI)I'essoI" cycles on and ()_]_
This sMtch must be set at Offin order to use
the tim settings (on the mode control).
O Timer
0
@
0n-iX,Vhen the air conditioner is off, it can be
set to automatically turn on in 1 to 24 hom_
at its previous setting. Each touch will set the
time in hom_.
0f/i_ hen the air conditioner is on, it can be
set to autolnaficallx turn off ill 1 to 24 houI_.
Each touch will set the time in hom_.
To cancel the timex; press the Timerpad
until the display time disappeais.
Sleep (on some models)
Press to set the air conditioner to run for
8 hom_ befin'e it automatically shuts off'.
One hour alter the sleep timer is set, the set
temperature will automatically increase 2°F.
To cancel the sleep mode, press the Sleep pad
a second tiIlle,
Note: Thesleep timerwill be cancelledff the
Timer,Energy Saver orMode pad is pressed.
RemoteControlSignal Receiver
Remote Control
iJi::To ensure proper operation, aim the
remote control at the signal receixer
on the air conditionei:
iJi::The remote control signal has a range of
up to 21 teet.
::Ji::Make sure nothing is between the air conditioner
and the remote control that could block the
signal.
::Ji::Make sure batteiies ale fl'esh and installed
correctly--see the Care and gleaning section.