To Next Page

To Previous Page

24 2062665-001 G

Sample Messages: Transactions from the monitor HL7 interface

OBX|43|NM|150456^MDC_PULS_OXIM_SAT_O2^MDC|1.22.1.2|10

0|262688^MDC_DIM_PERCENT^MDC|||||R|||||||080019FFFE0B

4020^B40_GE

OBX|44||69682^MDC_DEV_ANALY_AWAY_MULTI_PARAM_VMD^MDC|

1.20.0.0|||||||X

OBX|45|NM|151562^MDC_RESP_RATE^MDC|1.20.1.1|18|264928

^MDC_DIM_RESP_PER_MIN^MDC|||||R|||||||080019FFFE0B402

0^B40_GE

OBX|46||70666^MDC_DEV_ECG_RESP_VMD^MDC|1.6.0.0|||||||

OBX|47|NM|151562^MDC_RESP_RATE^MDC|1.6.1.1|30|264928^

MDC_DIM_RESP_PER_MIN^MDC|||||R|||||||080019FFFE0B4020

^B40_GE

OBX|48||69902^MDC_DEV_METER_TEMP_VMD^MDC|1.26.0.0||||

|||X

OBX|49|NM|150344^MDC_TEMP^MDC|1.26.1.1|37.1|268192^MD

C_DIM_DEGC^MDC|||||R|||||||080019FFFE0B4020^B40_GE

OBX|50|NM|150344^MDC_TEMP^MDC|1.26.1.2|36.5|268192^MD

C_DIM_DEGC^MDC|||||R|||||||080019FFFE0B4020^B40_GE

Application High Level Acknowledgment Messages

Overview

The monitor Outbound HL7 interface supports application level message

acknowledgments formatted as HL7 original mode acknowledgments. This

function allows the HIS receiving application to acknowledge receipt and

successful processing.The acknowledgment message returned to the sending

application is used to determine whether to log the message to the monitor

service error system.

The HL7 acknowledgment configuration is optional in monitor’s HL7 service

menu, which will require acknowledgment message to be sent back to monitor

or not from HL7 receiver system. The default acknowledgment configuration is

Enable in monitor HL7 service menu.

NOTE: GE recommends enabling the HL7 acknowledgement option in the

monitor's service menu. Disabling this option may miss some data, if

the HL7 receiver system has the feature of sending acknowledge

message.

Acknowledgment Message Composition

Acknowledgment messages contain the following HL7 interface segments:

 MSH — Message segment header

GE B40 User Manual

Questions and Answers: