GE CAFE CGY366 - Design Information; Product Dimensions and Clearances

4 31-2000814 Rev. 1
Design Information
PRODUCT DIMENSIONS AND CLEARANCES
16”
0D[
36” Min.
12” Minimum
to Adjacent Wall
Non-
Combustible
Material **
60” Minimum
to Combustibles
36” Minimum
18”
Min.
3” Min. 3” Min.
Island
Cutout
7RS9LHZ
´0LQ
WARNING
,QVWDOODWLRQVZLWKRXWD
hood require 60” minimum to combustibles.
$FXVWRPKRRGLQVWDOODWLRQZLWKH[SRVHG
horizontal combustible surfaces must have
an Auto-On feature. Refer to hood installation
instructions for specific hood clearances.
7KHVXUIDFHRIWKHHQWLUHEDFNZDOODERYH
WKHUDQJHDQGEHORZWKHKRRGPXVWEH
FRYHUHGZLWKDQRQFRPEXVWLEOHPDWHULDO
VXFKDVPHWDOFHUDPLFWLOHEULFNPDUEOHRU
other stone.
CAUTION
To prevent drafts from
DIIHFWLQJEXUQHURSHUDWLRQVHDODOORSHQLQJV
in floor under appliance and behind
DSSOLDQFHZDOO
** As defined in the National Fuel Gas Code (ANSI
=&6$%&XUUHQW(GLWLRQ&OHDUDQFHV
from non-combustible materials are not part of the
$16,=&6$VFRSHDQGDUHQRWFHUWLILHGE\
CSA. Clearances less than 12” must be approved by
ORFDOFRGHVDQGRUWKHDXWKRULW\KDYLQJMXULVGLFWLRQ
ADDITIONAL CLEARANCES:
$OORZ´PLQLPXPFOHDUDQFHWRDQDGMDFHQWZDOORQ
each side.
Working areas adjacent to the rangetop should have
´PLQLPXPFOHDUDQFHEHWZHHQFRXQWHUWRSDQGWKH
ERWWRPRIWKHZDOOFDELQHW
)RULVODQGLQVWDOODWLRQPDLQWDLQLQPLQLPXPIURP
cutout to back edge of countertop and 3 in. minimum
IURPFXWRXWWRVLGHHGJHVRIFRXQWHUWRSVHHWRSYLHZ
12”
Minimum
Each Side
Back
36”
´
´ 14”
*DV
Electric
´
2”
3”
Universal Utility Locations
´
Width
1”
Countertop
to Cooking
Surface
´WR´
Height to trim.
Trim to be flush
or higher than
countertop.
´'HSWKWR
Front of Bullnose
´'HSWK
to Front of Door
7RHNLFN
leg Height
´
WR´