READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.
SAVE THESE INSTRUCTIONS
4
IMPORTANT SAFETY INFORMATION.
READ ALL INSTRUCTIONS BEFORE USING.
WARNING
Suffocation and child entrapment hazard.
Remove fresh-food and freezer doors from the refrigerator, prior to disposal. Failure to do so can
result in child entrapment which can lead to death or brain damage.
Child entrapment and suffocation are not
problems of the past. Junked or abandoned
refrigerators are still dangerous even if they
will sit for “just a few days.” If you are getting
rid of your old refrigerator, please follow the
instructions below to help prevent accidents.
Before You Throw Away Your Old
Refrigerator or Freezer:
Take off the fresh food and freezer doors.
Leave the shelves in place so that children may
not easily climb inside.
Refrigerants
All refrigeration products contain refrigerants,
which under federal law must be removed prior
to product disposal. If you are getting rid of an old
refrigeration product, check with the company
handling the disposal about what to do.
PROPER DISPOSAL OF YOUR OLD REFRIGERATOR
IMPORTANT:
SAFETY (CONT.)
WARNING
Scalding Hazard.
The hot water dispenser is capable of heating water to a temperature of approximately 185°F (85°C).
Water temperatures above 125°F (52°C) can cause severe burns or death from scalding. Children, the
disabled, and the elderly are at highest risk of being scalded.
Use this appliance only for its intended purpose as described in this Owner’s Manual. To reduce the risk of severe burns,
scald injuries, or death when using your hot water dispenser, the instructions below must be followed:
HOT WATER DISPENSER
Do not permit children to use the hot water dispenser.
The hot water dispensing knob requires both twist and
push motions in order to reduce the risk of hot water being
dispensed unintentionally or by small children. Do not
tamper with or modify the hot water dispensing knob.
The water coming from the dispenser is very hot. Use
extreme caution when dispensing and drinking water. Allow
water to cool to a drinkable temperature before drinking.
When dispensing water below 125ÛF, always test the
temperature of the water before drinking.
When dispensing hot water, the container can become
very hot. Use a temperature insulating container, such as
ceramic or foam. Using container materials such as paper
or plastic may result in a burn while holding the cup. Do
not use glass containers, as thermal shock can cause the
container to break and may result in scalding or lacerations.
Always follow the formula manufacturer’s instructions for
preparation of baby formula.
Do not use with water that is microbiologically unsafe or of
unknown quality.
Your container should be close to the dispensing point to
minimize the splashing of hot water.
A newly installed water filter cartridge will cause water to
spurt from the dispenser. Run 2 gallons of water through
the cold water dispenser (about 5 minutes) to remove air
from the system. Until this air is removed from the system
through the cold water dispenser, DO NOT use the hot
water dispenser as it may result in spurting of hot water and
lead to hot water scalding.
The first time the hot water feature is used, confirm if
you live above 5000 feet (high altitude). This limits the
temperature of the hot water system to avoid boiling. To
access the high altitude selection, go to the settings menu.
The hot water dispenser is designed to only dispense water.
Do not attempt to heat or dispense anything other than
water. Do not attempt to disassemble or clean the tank.
The hot water dispensing tank is a non-pressurized tank,
with a vent on the tank and a dispenser tube outlet. Do
not modify the system, close or block the dispense tube, or
connect any other type of device to the tank or dispense
tube. Doing so may lead to rupture of the tank and hot
water scalding.
To Next Page
Loading...
Need help?
General
