35
• While heating water if the consumer presses one of the buttons on the user interface; Water,
Crushed, Cubed, Lock, Precise Fill, and Hot Water, the LCD screen will display 'Do You Want to
Cancel?‘ and continue to heat.
• If the consumer selected 'YES', The LCD screen will display 'Hot Water Canceled‘ for 3 seconds,
terminate water heating then go to the refrigerator home screen and the control will execute the
selected function.
• If the consumer selected 'NO', the LCD screen will revert to the previous screen and the control will
continue hot water operation.
• The Hot Water system is not active while the control is in ‘Sabbath’, ‘Demo’ or ‘Service’ modes.
• The USB uploading is disabled while the control is in Hot Water Dispense Mode (dispensing hot
water).
• If a Hot Water system fault occurs the UI screen will display 'Hot Water Canceled’. (See mini-
manual for fault codes)
• The Hot Water heating countdown time is only an estimate displayed in 15 minute intervals.
• Countdown timer can hold for more than 15 seconds at any time or skip a 15 second interval.
(examples: timer could go from 45 sec. to 15 sec. skipping 30 sec. )
• In ‘Purge Mode’ even though the pad says “Empty Tank’ the tank is not emptied it dispenses the
hot water which is replaced with filtered water.
• Hot Water works best with household water pressure of 40 to 100 PSI.
Hot Water Operation Notes
To Next Page
Loading...
Need help?
General
