Need help?Do you have a question about the GE CT ProSpeed Series and is the answer not in the manual?
General| Gantry Aperture | 70 cm |
|---|---|
| Type | Computed Tomography Scanner |
| Manufacturer | GE Healthcare |
| Scan Modes | Axial, Helical |
| X-ray Tube Voltage | 80 - 140 kV |
| X-ray Tube Current | 10 mA |
| Reconstruction Matrix | 512 x 512 |
| Power Requirements | Varies depending on the configuration |
Details required site preparations before installing the CT system.
Lists tools and test equipment needed for installation.
Procedures for preparing the floor and room for gantry and table installation.
Step-by-step guide for installing and leveling the gantry.
Step-by-step guide for installing and leveling the patient table.
Installation procedures for the Power Distribution Unit (PDU).
Installation procedures for the Qj-b type Operator Console.
Installation procedures for Zj/Zj-a type Operator Console.
Information on where to install option boards.
Procedures for installing the MOD (Magnetic Optical Disk) unit.
Instructions for installing the laser imager.
Installation procedures for the diagnostic console.
General guidelines and references for system cabling.
Details on cable interconnections for Qj type systems.
Wiring for scan room X-ray and system power status lights.
Safety interlocks related to the scan room door.
Details on cable interconnections for Zj type systems.
Wiring for scan room X-ray and system power lights for specific PDU models.
Important precautions before anchoring the gantry and table.
General procedures for anchoring the system components.
Specific steps for anchoring the gantry.
Specific steps for anchoring the patient table.
Instructions for installing trim cover panels on subsystems.
Applying data plates and labels to Qj/Q-b type systems.
Applying data plates and labels to Zj/Zj-a type systems.
Instructions for attaching the Operator Console emblem.
Instructions for attaching the gantry emblem.
Procedures for cleaning the installation room and equipment.
Steps to set the system language type.
Procedures for saving system data, including custom parameters.
Guide to identifying system components and their part numbers.
Overview of typical installation and check/adjustment procedures.
Detailed list of items for installation and check/adjustment procedures.
Explanation of symbols and classifications used in the manual.
To Next Page
