GE DDE7200S - Tools Needed

REVERS~LE DOOR mSTRUCTIONS
(on models so equipped)
Tools Needed
A phil lips screwdriver is needed to reverse the dryer door.
Dryer Door
1. Open the door and remove the filler plugs
6. Rotate the door 180°. Insert it
from the side of the opening without hinges.
on the opposite side of the
2. With the door
completely open,
remove the bottom
screw from each hinge
on the dryer face.
v
opening by moving the door
\@*., ‘ ~-
in and down until the top
hinge and the bottom hinge
\
are resting on the top screws
~ II )
inserted in step 3.
1
,, ,,, ,, ,
3. Insert these screws
J i ‘~
about half way into
* *,2
the top holes, for
L
)’ ~
I
each hinge, on the
o~~osite side. (Where
yb~ removed the filler plugs.)
4. Loosen the top screw from
each hinge on the dryer face
TT
10
II
5. With one hand holding the top
of the door and the other hand
holding the bottom, remove the
door from the dryer by lifting it up and out.
& l\\
7. Remove the remaining
screws from the side of
the opening from which
the door was removed. ‘
With these screws,
secure each hinge at
the bottom.
; o
G@
, @ Q- .
w
8. Tighten the two top
screws of each hinge.
9. Reinsert the plastic plugs on
the side from which the door was removed.