EasyManua.ls Logo

GE DDT700 Series - User Manual

GE DDT700 Series
26 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Write the model and serial
numbers here:
Model # _________________
Serial # _________________
You can find them on a label on
the tub wall just inside the door.
GE is a trademark of the General Electric Company. Manufactured under trademark license.
OWNER’S MANUAL
DISHWASHERS
49-4000214 Rev 0 08-19 GEA
ENGLISH/FRANÇAIS/
ESPAÑOL
GDF 565-645 Series
GDT 565-665 Series
GDP645 Series
DDT700 Series
PDT715-785 Series
PDP715 Series
Includes GE®, GE Profile™
Series and GE Adora
Series products
SAFETY INFORMATION .........4
USING THE DISHWASHER
Getting Started ........................6
Dispensers ...........................10
Appliance Communications ............12
Loading .............................13
CARE AND CLEANING ........... 20
TROUBLESHOOTING TIPS ......22
LIMITED WARRANTY ...........25
CONSUMER SUPPORT ......... 26

Table of Contents

Questions and Answers

  • M
    Michelle ReyesAug 19, 2025
    Why are my dishes not clean in my GE Dishwasher?
    • H
      Heidi DudleyAug 19, 2025
      There are several reasons why your dishes might not be getting clean. Check if the Ultra-Fine Filter or Fine Filter is clogged and refer to the Care and Cleaning section. Ensure the inlet water temperature is correct by running the hot water faucet nearest the dishwasher until the water temperature stops rising before starting the dishwasher. Also, verify that the water pressure is normal (20-120 psi). Other potential causes include a clogged air gap or disposer, improper rack loading (making sure large dishware does not block the detergent dispenser or the wash arms), or poor performing detergent. In addition, check that the high drain loop or air gap is properly installed according to the Installation Instructions.
  • W
    William HerreraAug 21, 2025
    Why don't dishes dry in my GE DDT700 Dishwasher?
    • R
      Richard KelleyAug 21, 2025
      Several factors can affect drying performance. Ensure the inlet water temperature is at least 120°F. Try selecting Boost Dry or using the Boost option. You might also select a higher cycle, such as Steam-Sani, Presoak- Sani, or Sanitize. Check the rinse agent dispenser and fill as required. For additional drying time, leave the door closed after the Clean light appears to allow the fan to run for an extra 90 minutes; opening the door will cancel this extension.
  • S
    shawsamanthaAug 23, 2025
    What to do if my GE DDT700 Dishwasher won’t run?
    • N
      nixontiffanyAug 23, 2025
      If your dishwasher won’t run, first check the fuse or circuit breaker and replace or reset if necessary, removing other appliances from the circuit. Ensure the power to the dishwasher is turned on, especially if it's controlled by a wall switch. Make sure the control panel is not locked; refer to the Getting started section for unlocking instructions. Also, ensure you are following the correct start sequence as described in the Using the dishwasher section.
  • B
    brandon69Aug 26, 2025
    What to do if GE DDT700 Dishwasher control panel works but it doesn't fill with water?
    • B
      brian57Aug 26, 2025
      If the control panel responds but the dishwasher doesn't fill with water, first ensure the door is completely closed. Check that the water valve (usually located under the sink) is turned on. Also, the flood float may be stuck; remove the Ultra-Fine filter and lightly tap the piece under it that looks like a salt shaker, then replace the filter.
  • R
    Randy ThomasAug 28, 2025
    Why is the start status light flashing on my GE DDT700?
    • D
      David JuarezAug 28, 2025
      The start status indicator light flashes when the door was opened or the cycle was interrupted. To restart the dishwasher, press the Start pad once and close the door within 4 seconds. If you wish to cancel the cycle, press the Start pad a second time while the dishwasher is running.
  • T
    Timothy SheltonAug 30, 2025
    Why does my GE Dishwasher beep every minute?
    • B
      Brian MoralesAug 30, 2025
      The beeping every minute is a reminder that your dishwasher door has been left open during operation. It will continue beeping until you press Start and close the door.
  • T
    taylorcalderonSep 2, 2025
    How to prevent spots on glasses in GE DDT700?
    • K
      kathleenvelasquezSep 2, 2025
      To prevent spots and filming on glasses and flatware, especially if you have extremely hard water, use rinse agents like Finish® Jet-Dry® Rinse Aid. Ensure your inlet water temperature is at least 120°F (49°C). Avoid overloading the dishwasher and load it properly as shown in the Loading section. Make sure your powder detergent is fresh and of high quality, such as Finish® Quantum® Automatic Dishwashing Detergent. Also, check and refill the rinse agent dispenser with a product like Finish® Jet-Dry® Rinse Aid, and ensure you are using the proper amount of a highly rated detergent.
  • C
    Christopher ZimmermanSep 4, 2025
    How to remove cloudiness from glassware in GE Dishwasher?
    • W
      William WebsterSep 4, 2025
      Cloudiness on glassware can be caused by a combination of soft water and too much detergent, leading to etching, which is permanent. To prevent this, use less detergent if you have soft water and wash glassware in the shortest cycle possible. Also, cloudiness can be caused by low performing phosphate-free detergent. Additionally, if the water temperature entering the dishwasher exceeds 150°F, it could cause etching, so lower the water heater temperature.
  • H
    heatherfowlerSep 6, 2025
    How to remove black marks from dishes in GE Dishwasher?
    • T
      thomasmichelleSep 6, 2025
      Black or gray marks on dishes are typically caused by aluminum utensils rubbing against them. Remove these marks with a mild, abrasive cleaner.
  • S
    Scott LeonardSep 8, 2025
    How to turn off beeping at end of cycle on GE Dishwasher?
    • E
      Elizabeth KingSep 9, 2025
      The dishwasher beeps twice at the end of the cycle, which is normal. To turn off this double beep indicator (or re-activate it if it was previously turned off), press the Dry Boost pad 5 times within 3 seconds. A triple beep will sound to indicate the end-of-cycle beep option has been turned on or off.

Summary

Safety Information

Installation and Maintenance Safety

Guidelines for safe installation, maintenance, and electrical connections.

Safe Dishwasher Operation

Essential precautions for safe daily use of the dishwasher.

Using the Dishwasher

Getting Started with Your Dishwasher

Proper Dishwasher Loading Techniques

Care and Cleaning

Maintenance of Filters and Air Gap

Dishwasher Troubleshooting

Cleaning Performance Issues

Solutions for dishes not coming out clean, spots, or filming.

Operational and Startup Problems

Troubleshooting common issues like the dishwasher not running or filling.

Drainage and Water Flow Issues

Resolving problems with water not draining or pumping out of the tub.

Film and Residue Resolution

GE DDT700 Series Specifications

General IconGeneral
BrandGE
ModelDDT700 Series
CategoryDishwasher
LanguageEnglish

Related product manuals