GE DISPOSALL GFC525N User Manual (English)

Questions and Answers:

J
Jose BridgesAug 10, 2025
What to do if my GE Garbage Disposal doesn't start?
- C
  Charlene LawsonAug 10, 2025
  First, with the splash guard removed, check if the turntable moves freely using a broom handle. If it does, replace the splash guard and check the red reset button, located opposite the discharge elbow near the bottom of the disposer, to see if it has been tripped. Push the button in until it clicks and remains depressed. If the reset button hasn't tripped, check for shorted or broken wires connected to the disposer, and inspect the electrical power switch, fuse box, or circuit breaker. If wiring and electrical components are intact, the unit may have internal problems requiring service or replacement.
A
andrea75Aug 16, 2025
How to fix loud noises from GE DISPOSALL GFC525N?
- J
  john21Aug 17, 2025
  To address loud noises (other than those during grinding of bones and fruit pits) in your GE Garbage Disposal, remove the splash guard and use long-handled tongs to remove any foreign objects. Then, replace the splash guard.
M
Miss Andrea WagnerAug 25, 2025
What to do if GE DISPOSALL GFC525N turntable cannot rotate?
- V
  Victor HuynhAug 25, 2025
  If the turntable doesn't turn freely, check for any object lodged between the turntable and the grinding ring. Dislodge the object by moving the turntable with a broom handle and then remove it. If no foreign object is present, there may be internal problems.
G
gibsonyvetteAug 31, 2025
Why is my GE DISPOSALL GFC525N leaking?
- D
  dwillisAug 31, 2025
  If the leak is at the top, it could be due to improper seating of the sink flange (gasket choice, putty, or tightening), the support ring not being tightened properly, or a defective cushion mount. If the leak is at the discharge elbow, it may be caused by improper tightening of the elbow flange screws.

GE DISPOSALL GFC525N Specifications

General

Horsepower	1/2 HP
Feed Type	Continuous Feed
Grinding Chamber Material	Galvanized Steel
Sound Insulation	Yes
Motor Speed	1725 RPM
Overload Protection	Yes
Grind Stages	1
Anti-Jamming Feature	Yes
Mounting Type	3-Bolt Mount
Voltage	120 V
Warranty	2 Years